Communication of Cluster Using Can Bus

https://doi.org/10.26552/com.C.2019.2.69-74

  • Matej Kubis
  • Miroslav Gutten
  • Daniel Korenciak
  • Matus Danko
DOI: https://doi.org/10.26552/com.C.2019.2.69-74
Keywords: communication, CAN bus, LabVIEW, automotive

Abstract

The paper deals with the communication between the infotainment elements and the drive component of the car using the CAN bus. In the introduction, there is briefly described the communication bus used in cars. It describes its basic features, benefits and utilization. The main task is graphically programmed and builds a dashboard that will resemble to a real dashboard from a Volkswagen Golf 5. Using the dashboard built in LabVIEW, it controls the real dashboard.

Author Biographies

Matej Kubis

Department of Measurements and Applied Electrical Engineering, Faculty of Electrical Engineering and Information Technology, University of Zilina, Slovakia

Miroslav Gutten

Department of Measurements and Applied Electrical Engineering, Faculty of Electrical Engineering and Information Technology, University of Zilina, Slovakia

Daniel Korenciak

Department of Measurements and Applied Electrical Engineering, Faculty of Electrical Engineering and Information Technology, University of Zilina, Slovakia

Matus Danko

Department of Mechatronics and Electronics, Faculty of Electrical Engineering and Information Technology, University of Zilina, Slovakia

Published
2019-05-24
How to Cite
Matej Kubis, Miroslav Gutten, Daniel Korenciak, & Matus Danko. (2019). Communication of Cluster Using Can Bus. Communications - Scientific Letters of the University of Zilina, 21(2), 69-74. https://doi.org/10.26552/com.C.2019.2.69-74
Issue
Vol 21 No 2 (2019)
Section
Electrical Engineering in Transport